1. Home > News >

Spiral Fruit Vegetable Juice Extractor Machine for Celery,Ginger

May 17, 2017Published by Wendy
This sprial fruit vegetaable juice extractor machine is suitable for the high fiber material to make juice , such as: ginger, wheat seedling, celery, etc. the juice extractor machine with slagging without clogging, the juice rate as high as 70% and so on, with spiral cutting, no broken.
sprial fruit juice extractor machine for ginger,celery manufacturerWhich is composed of a front support seat, a hopper, a screw, a filter, a juice collector, a rear bearing and a slag groove. The left end of the spiral spindle is supported in the rolling bearing seat and the right end is supported in the hand wheel housing. The work of the triangular pulley drive screw.

The main component of the equipment is the spiral, the spiral along the slag exit direction of the main diameter gradually increased and the pitch gradually reduced, when the material is screwed, due to the spiral cavity volume reduction, the formation of the material squeeze.

The direction of rotation of the helical spindle is seen from the feed hopper to the slag groove direction and is clockwise.

The raw material is fed into the hopper and is pressed under the advance of the screw, and the pressed juice flows into the bottom of the juice through the filter, and the waste is discharged through the annular voids formed between the helical and the tapered portions, The movement of the pan head in the axial direction adjusts the size of the void. For the clockwise (from the slag tank to the feed head to see the hand wheel when the handle, the pressure head to the left, the gap is reduced, otherwise the gap is larger.) Change the size of the gap, that is, adjust the row Slag resistance, you can change the slag rate, but if the gap is too small, in the strong squeeze, part of the slag particles and juice together through the filter was squeezed out, although the juice increased, but the relative quality of juice decreased, the gap The size of the user should be based on the specific process requirements.